Installing Vinyl Siding Under Windows

This will leave a panel with an intact nail hem and proper exposure.

Installing vinyl siding under windows. Mark the siding at 1 4 inch past the edge of each. Longer siding panels don t stretch as readily as smaller ones so they re not as easy to adjust if they get out of whack. Place the siding that has to be notched under the window. When installing vinyl siding on each side of a window or door start on the side that needs the longer panels.

Measure and cut panel to fit. Drop siding panel into j channel around top of window and install. Gap at all ends. When you get to a window you will need to cut sections from the panels directly above and below it to fit.

For more information refer to pages 28 32 of the vsi vinyl siding installation manual. Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes. B cut the siding to fit under windows. Place the piece of siding to be installed under the window along the bottom edge and hold it where it will be located horizontally along the wall.

Install siding at the top of a window or door in a similar fashion but this time set the siding on the window channel and use the window trim to mark the cut. Be sure to check both sides for proper fit. A mark the cuts for siding under the window. To prevent the relatively thin panels from buckling observe these fitting and nailing rules.

Fitting siding over windows. To install the siding if partial panels are required mark the line to cut by measuring from the edge of the lock of the panel and cut the panel to the proper width. Vinyl siding depends on a few special trim pieces that either hold everything together or hide the edges and ends of the panels. Install siding around windows.

Measure and cut panel in the same manner detailed in step 14 but cut lower portion instead of top. To get the depth of the notch measure the distance from the locking tab on the siding below to the undersill trim. Measure the width of the piece you need to cut by holding the length of siding against the window and marking the edge points on the panel with a pencil. Finishing top row of siding under eaves.